Bambu Lab P1S Slicer Profile for eSun ABS+
Reference starting points for Bambu Lab P1S and eSun ABS+: 255°C nozzle / 100°C bed, with 0.6mm retraction. These settings have not been independently tested by this site; verify the filament maker's guidance and calibrate your own setup.
🧪 Calibrate before a large print. Results vary with machine, nozzle, filament batch, humidity, and slicer. These are reference values, not verified or guaranteed settings. Check the filament manufacturer's published range and use a small test print to tune one variable at a time.
🔧 Slicer Parameters
| Parameter | Recommended Value | Range |
|---|---|---|
| Nozzle Temperature | 255°C | 245–265°C |
| Bed Temperature | 100°C | 95–110°C |
| Retraction Distance | 0.6 mm | — |
| Retraction Speed | 40 mm/s | — |
| Max Volumetric Speed | 16 mm³/s | — |
| Chamber Temperature | 55°C | — |
📋 Printer & Filament Details
| Printer | Details | Filament | Details |
|---|---|---|---|
| Model | Bambu Lab P1S | Brand | eSun |
| Type | Enclosed CoreXY | Material | ABS+ (ABS) |
| Drive | Direct Drive | Density | 1.04 g/cm³ |
| Nozzle | Hardened Steel 0.4mm | Drying | 85°C / 8hrs |
| Material | ABS | Filament Brand | eSun |
💡 Maker's Notes: eSun ABS+ on the P1S — enhanced impact strength over standard ABS. The P1S's 55°C chamber handles ABS+ well. Preheat chamber 10 minutes. Less odor than standard ABS. Glue stick on engineering plate.
🩺 Print Defects This Profile Helps Avoid
🔗 Other Filaments for Bambu Lab P1S
3D-Fuel Carbon Fiber Nylon — 275°C / 100°C bed • PA-CFColorFabb HT — 250°C / 80°C bed • Co-PolyesterColorFabb PLA/PHA — 215°C / 60°C bed • PLA-PHAeSun PLA+ — 210°C / 60°C bed • PLAeSun PLA Matte — 210°C / 60°C bed • PLAeSun TPU 95A — 230°C / 50°C bed • TPU